Dear AllIs there a qnh setting facility in pmdg -if so please advise how to access/apply itThanks.Bernie Lonnen

Yep Bernie,On the glare shield. To the left of the MCP you have the EFIS control panel.On the right top of that panel you have a dual knob for setting the pressure. CLicking ABOVE the knob between the units will change between hPa and inHg. Clicking ON the knob will set STD pressure, 29.92 inHg or 1013.2 hPa. CLicking to the LEFT of the knob will decrease the pressure and clicking to the RIGHT will consequently increase the pressure reading.Hope it helps,

many thanks -id-s that in the manual?Bernie Lonnen

Yes it is, 07_System_Operations.. page 60

Thanks PerBernie Lonnen

Hi allWhen online flying many Controllers provide QNH in millibar.How to set QnH in mb ?G

G

Guten Tag Mats, hPa and mbar is clear.Sorry my question was not clear enough.1st example)Controller says "QNH 2998" No prob where and how to set2998 on the GlareShiled.2nd example) Controller says "QNH 1005" Does GlareShield allow to switch from Inches to mbar? To look up a conversion tabel is as time consuming as to ask the controller for QNH in Inches .Hope i expressed myself more comprehensible now.G

Oh I see,Well. That question was actually answered in my first post in this thread. ;-)8<--- snipClicking ABOVE the knob between the units will change between hPa and inHg.8<--- snipTch

Mats, VergebungTomaten auf den Augen gehabt;-(Adjacent clickspot has been found now.Servus G