Hello together,i am trying to use my three throttles from the CH Flight Sim Yoke for the two Engines and Reverser.I use the left throttle for Eng 1 and the right throttle for Eng 2.Did anybody know how i can configure the middle-throttle (orig, for Prob) to work for the reversethrust of the PMDG737And please excuse my terrible english. Its 25 years since i learned it :-))Greetings W

Hi Werner,Program the following in your Control manager for the prop axis:Control type: up/downsteps: 8inc key: F2dec key: F1Put your prop lever in the full forward position during normal operations.When reverse thrust is required pull the lever back fully.At 60 knts push back forward and your at idle thrust again.The 8 steps are needed for full thrust reverser power.Good luck!Haromo

Hi Haromo,wow it works. Thank you very muchCUWerner

Hi,how to configure left throttle as ENG1 and right throttle as ENG2 ? I have CH FlightSim Yoke too..Thank you.

I'll have to keep this in mind when I get the CH Throttle Quadrant

That's a great idea, thanks for the tip!!Cheers,

Hi unkown,go to options/settings/select joystickaxis and than selct powerlever 1 and lever 2 - thats itWerner

Hi I'm having problems trying to assign commands to the yoke. I have the USB yoke, the first of three work for my throttle, but I can not program the other two. They worked when I first bought the yoke (only a few months old). I can't seem to assign anything to them. I go to options/settings/ select joystickaxis and I don't see powerlever 1 and lever 2. I see throttle axis, engine axis up to 4 etc. I can't seem to assing anything to them even though it's showing that it's assigned. They do work when I calibrate the yoke. Any idea's? :-grrHelp!!!Huggs Kittiex:)~ This system is: AMD 64 3500+ 939 ASUS A8V Deluxe with wifi GCorsair TwinX1024 3200 XL Pro 2 36gig W.D. Raptor drives in Raid256 X800 ProWindow xp homeAntec True power 550wThermaltake Premier V5000A caseCH USB Yoke and Rudder Pedals