Can any one help me to get the stairs down on the 737 600/700 NG thanks colin.

I would like to know the answer to this question myself. I have tried the fold wings command, the tailhook command and shift e 1 to shift e 4. It says there are four exits, I only see three of them operate and I do not see any stairs.

This is from the for the 600/700 model but applies to either variant:I.2) Map keys to operate the Air Stairs up and down:In order to animate the operation of the Air Stairs, we installed a very complex articulated stair model into the 737NGs that use the stairs in the real world. (You can tell this from reading the information in the User Interface....)If you have an airplane that uses Air Stairs and you would like to operate them, the following are some easy steps to help you!Within MSFS, access the CONTROLS menu, then the ASSIGNMENTS menu. Assign a key to EXTEND CONCORDE NOSE and VISOR FULLY (I recommend CTRL+F10) Assign a key to RETRACT CONCORDE NOSE and VISOR FULLY (I recommend CTRL+F9)Now the air stairs are mapped to your CTRL+F9 and CTRL+F10 keys so that you can operate them within MSFS! It is important to note that not every 737 includes the stair animation, as not all airlines order the stairs from Boeing! The stairs add a significant amount of weight to the basic shell of the airplane, so many airlines choose not to have them installed.You can normally determine if you model has air stairs by reading the User Interface information about the 737 you have chosen!Jim Karn[link:www.precisionmanuals.com]http://www.precisionmanuals.com/images/forum/pmdg_pf.jpg

i dunno if i'm bringing a thread from the dead but I assigned these exact keys, but I can extend it, but no retraction?