Gyroscope precession rate too high?

[Guest]

I disabled the gyroscope drift in FS2K2 because it was annoying. Now that I am flying for real I find that eliminating that from my scan has created a bad habit. I tried enabling it again but the precession rate seems rediculously high. In a real Cessna 152, I find that it might drift a few degrees over 15-20 minutes. In the sim, it can be off by 10 or 20 degrees in less than five minutes. Is this something that can be corrected in the cfg file somewhere? Thanks!David

[Guest]

The gyroscopic precession is so high, I'm tempted to have an A&P take a good look at my entire vacuum system! Yep, it's a bit aggressive in FS2002. I too disabled it. I believe that there is a way to fix this (somebody posted about it a couple of months ago). Unfortunately I never tried it nor can I remember what to change.

[Hessel_Oosten 0]

From Simon Evans over at the FSD forum:"As an alternative, leave it checked then amend the fs2002.cfg file line under the REALISM section as follows:-GyroEffect=0.0125000Somewhere between 0.0125 and 0.014 are the closest you'll get to the real thing within FS. Don't touch the slider in FS, the adjustment is way too coarse."Hessel Oosten