Jump to content

737 recirc fan sound


Recommended Posts

Posted

Hi, I recently attempted to replace the sound of the recirc fan in the 737 with one of my own i recorded off a real 737 and I got it in there fine but when i turn on FS, it plays nicely but at the end of the clip that I recorede it makes a very quick pause so that iot can replay the sound clip again, which isnt that bad but after about 20 mins it can get quite annoying. the origional recirc fan didnt do this...how can I make it not "skip" like that and just play one continuos loop? thank youTyler

Posted

You 'll need an editor for wave files to do this (like "sound forge" or if you use the nero suite to burn your cd's you'll find one there as well, which is called "wave editor" I believe.) Try to trim the sound at the end or the beginning to remove this annoying spot and while in the editor play the sound in "loop mode" to check it before saving. It might take more than one try to achieve a satisfying result, the key is to end the sound to the point where it sounds exactly as when it starts...Regards & jet blastChris Margaritopouloshttp://pelagus-air.freehomepage.com/Kristo...forumbanner.gif

Posted

hey thanks a lot chris i used the sound forge and i found a tiny little part at the end of the sound file that was just blank with no sound so i trimmed that off and now it works great thanks again,Tyler

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...