CH Yoke problem, please help

Tero:Your old problem revisited. Below is a copy of an email I sent to Greg that solved his problem you might want to try it.Hi Greg: I did some comparing and found that in your FS2002.cfg you have extra entries for joysticks. Do you have more than just CH Yoke and Pedals? More important though I noticed that in the FSUIPC file your axis were not calibrated correctly. So let's try something. 1. Make a back-up of your FSUIPC.ini file. 2. Open the FSUIPC.ini file within any word editor and scroll down to {JoystickCalibration} 3. Delete the entire section and replace with the section below (use copy & paste) {JoystickCalibration}FlapsSetControl=0MapThrottle=YesAileron=-13113,-841,841,13113Elevator=-9953,-1496,1495,9841Rudder=-12845,0,0,12846Throttle1=-16193,-12225,-5953,16192ReverserControl=66292AileronTrimControl=0RudderTrimControl=0Reverser=-16193,16192/2LeftBrake=-10131,512RightBrake=-10771,5124. Save, start FS2002 Note: MAKE SURE YOU DON'T MOVE YOUR THROTTLE ALL THE WAY BACK - IDLE WILL BE ABOUT 1/4" FORWARD. 5. While on the ground test your throttle, move it all the way back and your reversers should activate along with your speed brakes. Move it to positive thrust and back to idle and your speed brakes should reset and the engines should go to idle. Now check your mixture knob, push forward and the reversers should again activate. You will have to push the throttle forward and back to idle to reset your speed brakes again. Let's try the above and see if that solves the problem before we try anything else. Lamont