Hi Tuomas/Bob...thanks to your great help I have managed to set-up my momentary switches for the A/P functions...most seem to work fine now however, I still can't get a few to work. Here's the problem:1) Switches all set-up with correct SID's RID's etc. Key test confirms they are working2) On the switches that are working you can see the switch setting change to 0 or 1 when pushed in the switch set-up area.3) The switches that don't work do not change the little dot from yellow to green...just stays black4) I check the SID/RID matrix and the setting is changing to 1 or 0Its funny that some are recognized but others not...Any advice help ? any thanks...JB

1) is it (x) Active ?2) is it (x) Up Event or (x) Down event, you need either or both.3) is up/down value something that is not the same for both?4) does the test button work on the toolbar?Tuomas

Tuomas..here's the answers to your questions:1) is it (x) Active ?Yes2) is it (x) Up Event or (x) Down event, you need either or both.I have it set to Up event like you said3) is up/down value something that is not the same for both?Everything is set like each other..4) does the test button work on the toolbar?The test button does not work on the toolbar but it works on key test matrixHope this helps...thanks...JB