Hi everyone...I have just built a co-pilot's yoke for my King Air sim. It uses two pots - one for elevator and one for aileron and I want to interface it with FSBUS on my system. For my captain's Yoke I use a CH yoke.I wnet to try and install and set up but I have some questions:1) It set up nicely in FSBUS and added FS destinations for elevator and aileron's2) When I try and fly it will not work in FS9.3) I still have the CH yoke installed in FS9 and this runs fine4) Should I be doing something with my FSUIPC ?5) Should I disconnect the CH Yoke completely from FS9 ?6) Any ideas on how to get both working at same time ?Many thanks...JB

You cannot assign two different inputs to the same MSFS axis. If the CH Yoke is trying to tell MSFS that the aileron is in one position, and FSBUS is trying to tell it's in another..... whoops.Easiest and best way to do this is to PHYSICALLY link the two yokes, and have the pair turn only one set of pots.Richard