for you, iafpilot !

Hi,I saw your message in the "picture" forum.You must be shure that the Dauphin reaches his 100% power setting. I follow this procedure:1. Be sure the joystick is disabled.2. Shift-5 place both handles in the most upper position.3. If the electrical system is on, switch it off and back on. IMPORTANT !4. Be sure that all switches on the "electrical system" panel are switched "On". Be sure that the booster pumps are switched on!5. Shift-2 to be sure that the Dauphin system allows yoke control, Shift-2 to hide the panel again.6. Move the left handel just below the tab, and push the start button. At first the power needle is moving very slowly, move the handle slowly to the "flight" tab. 7. Wait a little until the needle reaches +/- 40%. Do the same procedure for the right handle. The short needle is now going up at a much faster rate to reach the power indication of the "left turbine power" needle.8. Be patient, wait until they reach now the 100% power. Practically the whole short green arc is covered now by the needles.Now you can fly the heli :-) !hm