Hi,,,used ASX since the 1st couple of days and its great....now ive got a 2nd computer and thought i`d network them and run ASX of the client.All seems set up ok i followed your instructions in the documents.I run the AI test prog from the server it connects to FSXI run it from the client it connects to FSX.I have fsx running on the server i then load ASX from the client,,i get the meesage in fsx that asx is connected.ASX loads,,and downloads the weather but right at the end after the parsing the messages,,it says data output thread startedthen the next line says "Problem writing weather values : The network path was not found (ERROR) source="now some times the weather loads into FSX and then again sometimes i get no weather BUT each time i get the metar bar in FSX saying weather depictedHas anybody any ideasI run Win XP on both computers Also noticed the weather map in ASX follows the aircraft.THANKSANDREW

Hi Andrew,Please make sure those 3 folders spoken about in the instructions are shared correctly, with write privileges.Thanks,Jimhttp://www.hifisim.com/banners/hifi-community-sigbanner.jpghttp://www.hifisim.com/

Thanks for the pointer Jim but i thought i`d set the sharing folders ok...ive dabbled with networking in the past,,i double checked everything and they were correct,,i could access the Dir`s from the client computer..so i thought i`d give the last resort a try,,the trusted reinstall of ASX..after install ALL OK it correctly applies the weather,,my guess is somewere i had pointed ASX to the wrong folders over the network,,anyway all is well nowThanks AgainAndrew