Guys,Got a slight issue with my CH Yoke, it's a USB one and the throttle slider is behaving irrationally. When i use the CH Centre to test the controller, the throttle when at "idle" is showing on the screen jumping up and down a little, whereas at "full throttle" there is no such jumping.This is having an effect on the FS situation, as it's impossible to select reverse thrust when the throttle is changing constantly to counteract the reverse selection - is there a way around this at all please?Thanks!Henry

Anybody please?Henry

Upcoming Flights

http://new-dimension.co.uk/flights.gifSoonLHR-CDG A320SCDG-LHR A320SAprilLHR-FRA LH4723 0905/1135 A306FRA-LHR LH4742 1935/2010 A306http://www.airline-images.co.uk

Hello Henry, I have a CH Products USB yoke as well. I notice noise coming from it all the time. Especially in VC when I look down at the throttle Quad, and it is jumping just alittle bit. If I move it ever so slightly, it stops. Is this what you have? If so, I think this is something alot of users have. A suggestion was CH Manager, but this messes me up more with certain aircraft.Do you use CH mgr software, or is the control center something else? I would think there is a way to control this issue.

Jeff,I'm using the CH Control Manager, I used it to configure the yoke and pedals as it says...but i still have this problem. The problem only occurs at the lowest 10% of the throttle range, but its enough to give me problems with selecting the reversers - any ideas?CheersHenry