Archived

This topic is now archived and is closed to further replies.

Guest klemon

VoxATC and My Traffix X

Recommended Posts

I was wondering if you could help me with a problem.I can't seem to get Vox ATC to work with My Traffic X.I have run both the panel setup and indexer after installing My Traffic X. My traffic slider in VoxAtc is set to 70%. When running the simulator with the Flight Simulator traffic slider at 0% (per the directions) I see no traffic at all (i.e. VoxATC is not generating traffic). When I set the Flight Simulator traffic slider to 50% I see the My Traffic aircraft normally, but they do not interact with Vox ATC. I tried a fresh install of Vox ATC as I installed My Traffic X after Vox ATC. I have a registered copy of Vox ATC. I can interact with the Vox ATC controller normally (with no other traffic). Prior to the installation of MyTraffic X Vox ATC was generating default plane traffic (both jet and GA) normally.I am running Windows Vista 64.There seems to be some step I am missing? Can you help me figure it out?Thanks,Kyle

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Hi Kyle,When you enable VoxATC you should get the normal voice test and then telling you which version of VoxATC you are using. Now right after that point you should get placement of aircraft at other parking spaces around you. You might try setting the aircraft traffic in VoxATC to 30% or less and see if that will get them to show. I am not sure if VoxATC will look at resources and then if you are pushing the CPU hard enough it won't generate the traffic.

Share this post


Link to post
Share on other sites