Newbie To FSCrew 737

[Guest revoraman]

Altho' I have successfully flown the FS2Crew PMDG 747-400 tutorial flight,I'm in a bit of a jam with the PMDG 737-700 tutorial flight.Have loaded the flight as per the tutorial instructions,i.e.Cessna at KSFO,etc,change aircraft to the 737-700 but get nowhere fast when I click on the C of the CPAL buttons to bring up the Config Panel even after waiting a full 15 mins.However,if I exit the default Cessna flight in the Dark+Cold status as per the tutorial instructions,and then without exiting FS9 load the PMDG 737-700 2D Panel aircraft at the same airport,gate,etc,when the displays are as they should be,i.e.Cold+Dark,but the engines are running,which clearly they should not be,all the FS2Crew panels are displayed and they have to be closed down one by one before I get to the Config Panel.But that is not as per the tutorial,so where am I going wrong.Please help,you experienced 737ers.Revo

[byork 2,259]

Hello Revo,So you clicked "C" and no Config Panel popped up?Please clarify.Cheers,

[Guest revoraman]

Hello Revo,So you clicked "C" and no Config Panel popped up?Please clarify.Cheers,

I had thought I had detailed everything in my question.Sorry if I missed something vital.I have followed the Tutorial instructions to the 't',yet when I change over from the default Cessna loaded at KSFO to the PMDG 737-700 without exiting FS9(i.e. via the Alt key-Aircraft-Select Aircraft menu),and load the fuel as per the Tutorial,even though I can clearly see the CPAL buttons,when I click on the 'C' absolutely nothing pops-up even if I wait for a good 15 mins.However,if I opt for Alt-Flights-End Flight and immediately load the PMDG 737-700 at the same airport/gate,several panels pop up and remain open till I right-click close them down till I eventually reach the Config Panel on the top left.But the engines are already running even though the dipsplays are 'Cold & Dark'.Bit weird to say the least!

[byork 2,259]

I had thought I had detailed everything in my question.Sorry if I missed something vital.I have followed the Tutorial instructions to the 't',yet when I change over from the default Cessna loaded at KSFO to the PMDG 737-700 without exiting FS9(i.e. via the Alt key-Aircraft-Select Aircraft menu),and load the fuel as per the Tutorial,even though I can clearly see the CPAL buttons,when I click on the 'C' absolutely nothing pops-up even if I wait for a good 15 mins.However,if I opt for Alt-Flights-End Flight and immediately load the PMDG 737-700 at the same airport/gate,several panels pop up and remain open till I right-click close them down till I eventually reach the Config Panel on the top left.But the engines are already running even though the dipsplays are 'Cold & Dark'.Bit weird to say the least!

Hi,I know the problem I think. Sounds like a license issue.Please email me: admin@fs2crew.comCheers,Bryan