I was tweaking my settings for performance and inadvertently turned off my airport signs (taxiway, runway, etc). Can anyone point me to the setting to turn them back on.Thanks

I was tweaking my settings for performance and inadvertently turned off my airport signs (taxiway, runway, etc). Can anyone point me to the setting to turn them back on.Thanks

Under settings\graphics\scenery You will find at the right side the scenery complexity and autogen density. I am pretty sure that the autogen should be at normal or above to see the signs

That was it. Thanks!Just to share my learnings...Scenery complexity must be set at normal (or higher) for airport signs to display.Autogen does not effect airport signs (at least at KSLC where I tested this out). I set autogen to zero and signs displayed fine.Thanks again for the help...