So i just installed fsx acceleration and when im in the virtual cockpit of an aircraft i get 30+ FPS (except the FA-18,if anyone could help with that too .it would be nice) But when i switch to the exterior view then my FPS are like 12 and the scenery is jumpey. Please someone help me...

So i just installed fsx acceleration and when im in the virtual cockpit of an aircraft i get 30+ FPS (except the FA-18,if anyone could help with that too .it would be nice) But when i switch to the exterior view then my FPS are like 12 and the scenery is jumpey. Please someone help me...

Nick's tuning guide might be able to help you ... http://www.simforums.com/forums/forum_posts.asp?TID=29041

Nick's tuning guide might be able to help you ... http://www.simforums.com/forums/forum_posts.asp?TID=29041

Thanks it helped a little but it still shutters but i have really good fps its very odd

Thanks it helped a little but it still shutters but i have really good fps its very odd

Hehe!Can't get everything, eh?You have to go take the advise from Mister Nick from A to B, C to Z etc.Do not skip anything, you'll be amazed when done!Hmmm... 30+ FPS in VC, not bad, really...Remember, when you change to outside view the FPS off course decreases, lots of more stuff to load and view...

First off, i think fsx performs much smoother with sp1 and sp2 instead of acceleration. 3 times i have put acceleration on my system, and removed it again. Last time i removed acceleration cause it makes the plane loose control when you use time accelleration, tried with sp2 and no such issues.I normally get higher fps outside than inside, few points1 - check your aircraft detail complexity in fsx settings maybe too high.2 - Have you installed the right SDk, in your case acceleration SDK3 - Try another plane , see if you still getting more fps outside than inside.4 - Defrag defrag defrag5 - If you using cpu with 4 cores try fsx affinitymask of 14, moves fsx to last four cores so things can be smoother generally6 - FSX is always smoother if you set fps limit to a value that is slightly less than the average your cpu can handle. my fps set to 40, my system can average 60fps. [email protected] gigs.

Thanks it helped a little but it still shutters but i have really good fps its very odd

Have you applied any other tweaks other than what Nick recommends?If so one or more could be the problem.Plus if you are using a quad then set affinitymask to either 3 or 15. (2 cores or 4 cores)