Since there isn't a section in the other part for Wilco....Flying the Vol 2 today, can't get the auto pilot to do anything with my alititude. Have the AP on of course and have an altitude selected and clicking with the mouse on the alt knob which usually results in a climb and can usually select my climb rate. Not working at all.Something I've missed? Seem to be doing it as by the book. This is the only time I've ever had this issue, even uninstalled and reinstalled too.Happens with all my Wilco airbusses. I'm hoping for a simple solution as this has never happened before. All I can say is a few months ago my pc was reinstalled, including the airbus obviously, but haven't flown for months so have only discovered that the altitude hold, level change isn't working.

Flying the Vol 2

old support forum contains years of information -http://iemit.com/forum(not open to new posts, in addition to the airbus sub-forum be sure to search the general sub-forum using 'airbus' in your search string)current support -http://forum.iemit.com(open to new posts, registration required, search the general support forum using 'airbus' in your search string)--

Not really a support forum is it, let's be honest, questions asked there are deleted.I assume it's just a temporary glitch, as if there was an answer, I may have had it by now.Never had this issue before, so I should be able to resolve it eventually.

Just testing again.Take off, initial climb selected to 9,000ft, pull on the v/s control, climb rate is +1700ft/m.If I try to adjust the climb rate, it goes to +600. If I try to get that higher, it goes to +200, then +100. I can't get the free adjustment that I used to have.Whatever the vs on the FCU, is not always what the aircraft is doing. AP is on.

Sorted.Since my reinstallation, I needed a later version of FSUIPC.

...or so I thought.... :(