November 14, 201015 yr Just downloaded Tinmouse 737, outstanding panel! Everything works great except for DME readout on RMI and HSI doesn't display. I have the switch in the center on nav panel. What am i doing wrong, can anyone help?Thanks. Zeke439
November 15, 201015 yr Just downloaded Tinmouse 737, outstanding panel! Everything works great except for DME readout on RMI and HSI doesn't display. I have the switch in the center on nav panel. What am i doing wrong, can anyone help?Make sure the Nav/Rad switch next to the HSI is in NAV. It sounds like the distance readouts are slaved to the LNAV.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO Bob Scott | President and CEO, AVSIM Inc ATP Gulfstream II-III-IV-V Sys1 (MSFS20+24/XPlane12+11): AMD 9800X3D, water 2x240mm, MSI MPG X670E Carbon, 64GB GSkill 6000/30, nVidia RTX4090FE Alienware AW3821DW 38" 21:9 GSync, 2x4TB Crucial T705 PCIe5 + 2x2TB Samsung 990 SSD, EVGA 1000P2 PSU, 12.9" iPad Pro Thrustmaster TCA Boeing Yoke, TCA Airbus Sidestick, Twin TCA Airbus Throttle quads, PFC Cirrus Pedals, Coolermaster HAF932 case Sys2 (P3Dv5/v4): i9-13900KS, water 2x360mm, ASUS Z790 Hero, 32GB GSkill 7800MHz CAS36, ASUS RTX4090 Samsung 55" JS8500 4K TV@60Hz, 3x 2TB WD SN850X 1x 4TB Crucial P3 M.2 NVME SSD, EVGA 1600T2 PSU Fiber link to Yamaha RX-V467 Home Theater Receiver, Polk/Klipsch 6" bookshelf speakers, Polk 12" subwoofer, 12.9" iPad Pro PFC yoke/throttle quad/pedals with custom Hall sensor retrofit, Thermaltake View 71 case, Stream Deck XL button box Sys3 (DCS/P3Dv4/ATS/ETS): AMD 7800X3D, MSI MPG X870E Carbon, Noctua NH-D15S, 64GB GSkill 6000/30, EVGA RTX3090 Alienware AW3420DW 34" 21:9 GSync, Corsair HX1000i PSU, 4TB Crucial T705 PCIe5 + 2TB Samsung 970Evo Plus, TM TCA Officer Pack, Saitek combat pedals, TM Warthog, TM RS300 FF wheel/pedals, Coolermaster HAF XB case
November 15, 201015 yr It sounds like the distance readouts are slaved to the LNAV.Which LNAV is that, Bob?
November 15, 201015 yr Which LNAV is that, Bob?The FS GPS, the CIVA INS (if installed), or the ISG FMS (if installed).That said, after re-reading the OP, I note that the RMI DME should not be affected, just the distance readout in the HSI.If the RMI DME indicator is not indicating (assuming the acft is powered and the busses are in a normal config, and there's a valid VOR DME station tuned) then perhaps try starting over with a default C172 and make sure the Avionics Master Switch is on before switching to the 'mouse.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO Bob Scott | President and CEO, AVSIM Inc ATP Gulfstream II-III-IV-V Sys1 (MSFS20+24/XPlane12+11): AMD 9800X3D, water 2x240mm, MSI MPG X670E Carbon, 64GB GSkill 6000/30, nVidia RTX4090FE Alienware AW3821DW 38" 21:9 GSync, 2x4TB Crucial T705 PCIe5 + 2x2TB Samsung 990 SSD, EVGA 1000P2 PSU, 12.9" iPad Pro Thrustmaster TCA Boeing Yoke, TCA Airbus Sidestick, Twin TCA Airbus Throttle quads, PFC Cirrus Pedals, Coolermaster HAF932 case Sys2 (P3Dv5/v4): i9-13900KS, water 2x360mm, ASUS Z790 Hero, 32GB GSkill 7800MHz CAS36, ASUS RTX4090 Samsung 55" JS8500 4K TV@60Hz, 3x 2TB WD SN850X 1x 4TB Crucial P3 M.2 NVME SSD, EVGA 1600T2 PSU Fiber link to Yamaha RX-V467 Home Theater Receiver, Polk/Klipsch 6" bookshelf speakers, Polk 12" subwoofer, 12.9" iPad Pro PFC yoke/throttle quad/pedals with custom Hall sensor retrofit, Thermaltake View 71 case, Stream Deck XL button box Sys3 (DCS/P3Dv4/ATS/ETS): AMD 7800X3D, MSI MPG X870E Carbon, Noctua NH-D15S, 64GB GSkill 6000/30, EVGA RTX3090 Alienware AW3420DW 34" 21:9 GSync, Corsair HX1000i PSU, 4TB Crucial T705 PCIe5 + 2TB Samsung 970Evo Plus, TM TCA Officer Pack, Saitek combat pedals, TM Warthog, TM RS300 FF wheel/pedals, Coolermaster HAF XB case
November 16, 201015 yr Author The FS GPS, the CIVA INS (if installed), or the ISG FMS (if installed).That said, after re-reading the OP, I note that the RMI DME should not be affected, just the distance readout in the HSI.If the RMI DME indicator is not indicating (assuming the acft is powered and the busses are in a normal config, and there's a valid VOR DME station tuned) then perhaps try starting over with a default C172 and make sure the Avionics Master Switch is on before switching to the 'mouse.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, COHi Bob,I tried starting out with the C 172, made sure the Avionics switch was on. Changed over to the Tin Mouse 737 and still nothing, the only way i can get the DME to come upon the HSI is if i toggle the Nav/Rad and program the GPS.Brent
November 16, 201015 yr Hi Bob,I tried starting out with the C 172, made sure the Avionics switch was on. Changed over to the Tin Mouse 737 and still nothing, the only way i can get the DME to come upon the HSI is if i toggle the Nav/Rad and program the GPS.BrentHi Brent,Apologies if this is too obvious, but have you confirmed that the switches on the Nav radios are on DME, not STBY?Rob (still trying to figure out my INS -> HSI issue...) Wilkinson
November 17, 201015 yr Author Hi Brent,Apologies if this is too obvious, but have you confirmed that the switches on the Nav radios are on DME, not STBY?Rob (still trying to figure out my INS -> HSI issue...) WilkinsonYes, the Nav Switches are both on DME.Does anyone know where i can get the lastest download for TimMouse? Maybe i have a old one?Brent
November 17, 201015 yr Yes, the Nav Switches are both on DME.Does anyone know where i can get the lastest download for TimMouse? Maybe i have a old one?BrentHere on AVSIM. The links are posted in the FAQ in this forum.One other thought...please ensure that you are using the registered version of FSUIPC...I made changes to the DME code in the last version that requires it, in order to eliminate some slow update behavior.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO Bob Scott | President and CEO, AVSIM Inc ATP Gulfstream II-III-IV-V Sys1 (MSFS20+24/XPlane12+11): AMD 9800X3D, water 2x240mm, MSI MPG X670E Carbon, 64GB GSkill 6000/30, nVidia RTX4090FE Alienware AW3821DW 38" 21:9 GSync, 2x4TB Crucial T705 PCIe5 + 2x2TB Samsung 990 SSD, EVGA 1000P2 PSU, 12.9" iPad Pro Thrustmaster TCA Boeing Yoke, TCA Airbus Sidestick, Twin TCA Airbus Throttle quads, PFC Cirrus Pedals, Coolermaster HAF932 case Sys2 (P3Dv5/v4): i9-13900KS, water 2x360mm, ASUS Z790 Hero, 32GB GSkill 7800MHz CAS36, ASUS RTX4090 Samsung 55" JS8500 4K TV@60Hz, 3x 2TB WD SN850X 1x 4TB Crucial P3 M.2 NVME SSD, EVGA 1600T2 PSU Fiber link to Yamaha RX-V467 Home Theater Receiver, Polk/Klipsch 6" bookshelf speakers, Polk 12" subwoofer, 12.9" iPad Pro PFC yoke/throttle quad/pedals with custom Hall sensor retrofit, Thermaltake View 71 case, Stream Deck XL button box Sys3 (DCS/P3Dv4/ATS/ETS): AMD 7800X3D, MSI MPG X870E Carbon, Noctua NH-D15S, 64GB GSkill 6000/30, EVGA RTX3090 Alienware AW3420DW 34" 21:9 GSync, Corsair HX1000i PSU, 4TB Crucial T705 PCIe5 + 2TB Samsung 970Evo Plus, TM TCA Officer Pack, Saitek combat pedals, TM Warthog, TM RS300 FF wheel/pedals, Coolermaster HAF XB case
December 3, 201015 yr Author Here on AVSIM. The links are posted in the FAQ in this forum.One other thought...please ensure that you are using the registered version of FSUIPC...I made changes to the DME code in the last version that requires it, in order to eliminate some slow update behavior.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, COJust reinstalled TinMouse with updated FSUIPC and everything works great! Now i get the DME readout on the RMI and HSI. Thanks Bob.Brent
Create an account or sign in to comment