Hi,I downloaded a Cheetah C by Jason Ashworth from Mirage4fs that uses the default Learjets panel.I then downloaded a Cheetah panel that is intended for use with the above mentioned Cheetah C - also from Mirage4fs.Unfortunately, there's not any installation guide in the panel's readme file and I have never before installed new panels on any aircraft.I suppose I have to delete the defualt Lear panel form the Cheetah and install the proper one in a certain way.I would appreciate it very much if anyone could give me step by step instructions on doing this.RegardsLodewyk Engels

Hi;If the panel you have downloaded is in a folder all you need to do is replace the original "panel" folder within the "aircraft" folder with the new one. If it is not, then put all the files into a folder and title it "panel". I always rename the original one "panelorig" just in case there is a problem with the new one so I can go back to it. Then add the new panel to the aircraft folder.Your new panel should have within it's folder a panel.CFG and any panel BMP's that are used with it. Once you replace the folder just load the aircraft and you should see the new panel. maxsdad

Thanks a lot, I got it right!!I just want to make sure - if I rename the original panel folder it is not necesary to remove it?RegardsLodewyk

Yep. That way you can have several panels in the same plane folder. Just give them a unique name and reference that name in the aircraft.cfg file. I often use this technique to trial different panels or sound sets before settling on one.At one point I was flying my POSKY CRJ-200 with four different panels before finally picking one.-------------------Racartronit means something, but I just can't remember what