Satiek Pro Yoke System Help

[DeckerZ 0]

Hi guys, I have recently bought a Satiek Pro Yoke System, with the Throttle Quadrant for use with my FSX setup. I downloaded a profile from Satiek's web site for FSX and was wondering if anyone has managed to reprogram the X & Y levers? The Z is fine for the throtle and reverse thrust, but the X & Y don't seem to do anything in FSX. I was wanting to program one (X) for elevator trim up and down and the other (Y) for rudder left and right. Has anyone done this or could anyone help me achieve this as I am quite confused about the profile editor from Satiek. Thanks in advance.

[Guest jahman]

Make sure you're using the SPAD driver. Cheers, - jahman.

[DeckerZ 0]

I didn't know about the SPAD drivers, I'll give it a go. Should I remove all the Saitek drivers including the profiler?

[Guest jahman]

Back-up your profiles first, just in case you want to revert. BTW I don't use SPAD because I don't have Saitek gear so I can't really give you detailed advice, but I would suggest any documentation that comes with SPAD would be a good place to start! :-) Cheers, - jahman.

[DeckerZ 0]

Hey Jahman, thanks for your advice. I installed SPAD and it worked with the hardware. I went into FSUIPC and changed the levers settings and all is working now. I have the X as the elevator trim, and the Y lever as the rudder. They a a bit sensitive but I just had a quick look and need to go in and adjust what I can to dampen the sensitivities. Thanks again for your advice.

[Guest jahman]

Your welcome, but the real credit is due to SPAD-Man! :-) Cheers, - jahman.