Archived

This topic is now archived and is closed to further replies.

CubanPete

Engine #2 power loss during take off roll

Recommended Posts

Hello!I searched for the problem I have, but I didn't find a topic.Here's my problem: sometimes during take off roll the engine #2 looses power and goes back to idle. It happens usualy approximately 10 secs before v1. A/T is on, TO/GA is active, FMC is setup correctly. No failures are active, no warnings in the cockpit. With a small movement on the thrustlever I can "restore" the take off thrust. I use the saitek yoke system but had the same problem with my old logitek joystick.Has anybody a similar issue?

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

do you have any other device linked to your computer that could send commands like z-axis to zero

Share this post


Link to post
Share on other sites

i have only connected the yoke with the quadrant and the saitek pedals, but as i had the same issue with my logitech joystick the pedals were not connect.

Share this post


Link to post
Share on other sites