Hi Fellow CaptainsI Have recently upgraded my Computer and re-installing etc..Having installed my USB CH Flight Sim Yoke and Pedels, my throttle now operates reverse thrust when in the idle position. This happens with all aircraft with reverse which I used to use F6 and F7 for. I would be most grateful for advice with my problem.I have FSUIPC (3.2) registered, and also CH Control Manager on FS9.thanksBob WrightP4 2:53 XP pro

Sounds like you need to recalibrate your throttle in FSUIPC Bob.Open FSUIPC and go to the joysticks tab and then the throttle page.Click the 'set' box for the throttle and move the throttle through its full range, you should see the values change.Set the throttle at its idle position and press the centre 'set' box.Move the throttle fully forward and press the 'set' box with the highest reading.Move the throttle fully back and click the 'set' box with the minimum value.Now move the throttle forward to idle position again and then back slightly, press the centre 'set' box again.There should now be a difference in the two centre vaules, this will create a dead zone between idle and reverse thrust so you do not get reverse unintentionally.You may need to adjust the centre values to get them jsut right.If you don't want the throttle to activate reverse thrust then just set the two outer 'set' boxes.You may also want to modify and lock the joystick section of fs9.cfg as entioned in the FSUIPC docs.HTH