AI Traffic do not land, just pop up at the gates or ramps, help desperately needed pleeeeeeeeeeeease!!!!!

Sorry Mercury, no help. If an AI flightplan is designed to fly a plane from airport A, to airport B, then on to airport C, then you'll see the plane land at B and later depart from B. If however, a flightplan starts at B, then the plane just -- APPEARS. It must be magic. R-

Hey Ron, thanks for the info. Do you possibly know of any freeware that can track the aircrafts with additional info (times,airports,type,etc)?

Hi,What do you mean "just pop up"? When you load an airport, the traffic that should already be there will be present at the airport. They will taxi and take off at some later time.The arriving aircraft will not approach the airport for 10-20 minutes after you use the GoTo menu to load an airport. They start far away.Hope this helps,--Tom GibsonCal Classic Propliner Page: http://www.calclassic.comFreeflight Design Shop: http://www.freeflightdesign.comDrop by! ___x_x_(")_x_x___

Hi Tom, i picked a Delta 777 at Frankfurt for example, changed the UTC setting in FS until it was gone, then returned minute after minute to see the aircraft land, no way, just showed up again at thegate

How long did you wait after each reset of the time? It takes 10-20 minutes for the plane to appear for landing.After resetting the time and the plane disappears, try pressing Ctrl-W over and over until you see all the AI planes in your area.Hope this helps,--Tom GibsonCal Classic Propliner Page: http://www.calclassic.comFreeflight Design Shop: http://www.freeflightdesign.comDrop by! ___x_x_(")_x_x___

Might be easier to use the Traffic ToolBox from http://www.microsoft.com/games/flightsimulator/ , downloads, FS2004SDK. W. Sieffert

Thanks for your suggestions peoples, will give it a try