So i use fsx with three monitors.

My main monitor is ( I thought ! ) the highest quality moniter i own.I run it at 1200x1920

The problem is that the main monitor gives me the blurries the others do not.

Now you may say, just change them around.

I could do that quite easily but i would like to understand why this would be problem with one monitor and not the others

?

The only thing i could think of is fresh rate .

Note all monitor use a dvi

nvidia cards are gtx 580

Thanks peter

Refresh rate is most likely the cause, that or just pixel response. You can verify your screen's refresh rate in your display settings. Make sure it's set to 60Hz. If it is and you still experience the issue, you can try driving a higher refresh rate to force a faster pixel response. I saw a post on overclock.net about how to do this using a utility, I'll see if I can find it again.

Refresh rate is most likely the cause, that or just pixel response. You can verify your screen's refresh rate in your display settings. Make sure it's set to 60Hz. If it is and you still experience the issue, you can try driving a higher refresh rate to force a faster pixel response. I saw a post on overclock.net about how to do this using a utility, I'll see if I can find it again.

 

thanks. . interesting how much of a difference it can make

pete

So I tried that , it was already at 60 hz...... perplexed

What are the make and model of the monitor? It would be worthwhile to find out what the pixel response time is.