Archived

This topic is now archived and is closed to further replies.

PC Pilot Dave

Problems with z-axis using Saitek Cyborg X

Recommended Posts

Hello all,

 

I currently use the Saitek Cyborg X joystick for flying in FSX. I've had the controller for several years now without much incident, but over the past several weeks I've noticed my aircraft making sharp pulls to the right. I started to look at the joystick calibration settings and noticed that the Z axis was going full on if I made even the slightest right turn. I've tried playing with the settings a bit, but to no avail so far.

 

Has anyone else run into this issue? Were you able to find a solution?

 

Worst case scenario - would anyone recommend an inexpensive replacement? (I'm hoping to get a yoke and rudders pedals soon when I move and have more space).

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!