September 22, 201312 yr Is there a way to move them together ? I currently move them one by one...creates a lot of yaw as you can imagine .... Thanks
September 22, 201312 yr Commercial Member Are you using an input device or the assigned keys on the keyboard. prop/condition levers are moved in unison so as to avoid - as you said it erratic yaw behavior, preferably slowly so as not to get the props too much out of sync (of course this is taken care of by the prop sync switch as well). If you are using the keyboard - the default prop lever assignments are CTRL+F2 for reduction and CTRL+F3 to increase (these two keys also allow for small adjustments), as CRTL+F1 & F2 take the levers to their full stops (backward and forwards). Depending on what throttle quadrant device you are using, simply configure the prop/condition levers either in FSX or FSUPIC, and this will allow you to move the levers in tandem. KROSWYND a.k.a KILO_WHISKEYMajestic Software Development/Support Sys 1: AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2: i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware: Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM gripSIMULATORS: MSFS2020/XP12/P3D v5.4 & v6: YouTube Videos
Create an account or sign in to comment