Not sure which is giving this problem but when I toggle pause on and off my view will change a bit (see pics below ) I set my view ezdok by pressing 2 adjusting it then press 2 again just like usual. Then when I toggle pause off so I can look around my view will jump up higher and closer to the dash. It used to be that when I hit pause it would just stop my view right where it was.  It used to just smoothly stop and start when I toggled on and off. Not sure if I change something by accident any thoughts appreciated. PS I have precision on.

Sooo   ...EZCA - Options - TrackIR - "Reset TIR Coordinates.... yada-yada.."

 

like this here:-

 

 

You probably have that little square "checked".