I have looked at multiple videos and read through many ways to set FSUIPC with a joystick. Mine specifically being the Logitech Attack 3. The calibration always goes wrong and FSUIPC ends up calibrating my joystick so if I turn left or right. I go up or down. Note, this is always set on the elevator trim for calibration. The thing is, while calibrating my joystick the values it calculates while I do it always changes. It might be -16,000 and then I do it again and it ends up being -5000. Anyone who has a fully detailed way of setting the Attack 3 joystick with FSUIPC. 

I have the same stick , two of them but I don't have the registered version of FSUIPC else I would have helped you.

 

IIRC I had seen a video of FSUIPC you need to set the center hmm can't explain but you need to zero it.

Dane, are you sure your joystick is not faulty?

I use the same one when flying AXE, have a registered FSUIPC, and don't remember any problem.

What if you try to callibrate it externally? In Windows or Logitech software? Does it react correctly?

Dane, are you sure your joystick is not faulty?

I use the same one when flying AXE, have a registered FSUIPC, and don't remember any problem.

What if you try to callibrate it externally? In Windows or Logitech software? Does it react correctly?

Nope the joystick is not faulty as tested in the Logitech calibration program. Recently I tried it again and the values were correct but all I need is some instruction for how to bind my controls.