ILS rwy 23L at Li

[gigi47be 0]

Hello all,I am looking for a solution to the following problem.Li

[ronzie 21]

AFCAD2.21 for FS9 allows you to set ILS properties allowing you to set either or both as active. In FS9 if a shared frequency is used for ILS you might get the wrong one until you are just a few degrees within the localizer beam. Use your audio announciator (morse code ID) or if equipped your navaid ID display to identify the correct ILS before commencing the final approach stages to insure you are receiving the correct one.From your post I'm not clear if you are using FS2K2 but a 1.x version of AFCAD is for that. I don't recall if in FS2K2 you can set ILS properties.

[gigi47be 0]

Hello Ronzie,I am using FS2K4.Your answer is exactly what I needed.I thank you very much for your help Sir.Kind regardsGilbert De Witte