VOXATC will not give me permission to start and engine.  The radio check works and I can listen to ATC.  I keep getting "Unable to..." or "Pass your message".  If I skip that part and continue it seems to work but I still seem to get a lot of these messages throughout the process.  So many in fact that the application is virtually unusable.

 

Alan

 

Apologies when I posted this I received an error telling me that I was not allowed so I tried again only to find that it had been submitted but I can't see a way to delete one.

What ver of VOXATC are you using?

 

Have you run the indexer?

 

Is the Level D nav data installed and its location set up in the VOXATC config?

 

Are you loading a flight with a saved FSX flight plan?

 

Is the flight plan IFR or VFR?

 

Have you opened the 2nd window to see whats been said ... just incase you missed an instruction its looking for a readback.

 

Have you pressed '0' to see if any options are avialabe?

 

If you are in a flight opened with a flight plan (or with 6.46 loaded a flight plan) and everythings loaded on when you start VOXATC you shouldnt have too many issues.

 

Rich

Yes to most of that although I have no idea what level D Nav data is.  No matter, VOXATC seems much happier with the command "Pushback and Start" even though I'm flying a Cesna 172 and I would not have thought it was relevant.  At least I can progress now.  Being able to pull up the prompt menu is also very handy.

 

Thank you

 

Alan