Prepar3D 2.4 + TrackIR + EZDOK 1.17 trackir pause view not working correctly

I'm having an issue i'm hoping someone has run into..

With trackir i have my one left front button on my yoke set to pause the view when looking around and the right side button set to re-center.

This works perfectly fine until EZDOK is launched.

If i run the 1.17 for FSX version, even with the box unticked in trackir settings (for ezdok) to reset view if out of range.. each time i press pause the view snaps back almost like the center button does (but not quite the same view).

Then if i try 1.17 beta for p3d.. it works somewhat better.. the pause will pause, but it will shift from where it was when i pressed pause by a few inches.

This is on trackir v5 hardware and the latest software.

I've also tried assigning the pause to keyboard commands to rule out conflicts.. my guess is some hot key in ezdok is interfering, but looking at the keyboard shortcuts i dont see how or which it could be.

Anyone ran into this?

Thanks