Hi there!

I downloaded the most recent version of the JAR Design A320neo today, installed it, activated it without a problem, but something isn´t working correctly. I had no problems with my setup on v2.2, but now, the flight controls behave very strangely after the engine start. The range of the elevator axis is very limited, and when I move the aileron axis and put the stick into the center position again, the ailerons stay in the full left/right position until I move the stick fully into the opposite direction again.

Taking off is nearly impossible that way, but when I make it into the air, everything is working nicely again (A/P and handflying). My Joystick is set up and calibrated correctly within XPX, and all other adons work as they should.

Unfortunately, the support of JAR Design ist done through the org forum,, from which I am banned.

So if you have any idea, please let me know!

Thanks in advance!

Michael,

              I have the A320 neo updated to v. 2.3 and have not experienced any problems with the flight controls. I know this is probably a silly question, but have you tried doing a reinstall of the A320?

I tried a fresh install (unzipping and pasting into the folder) and activation, yes.

It might be caused by a scenery anomality in the freeware LOWS scenery. I have to try it on a default airport!