Issues in P3D

[SirStiggie 63]

Purchased and installed the T7 for P3D last night and have a found a couple of issues so far:

 

1. Tried loading requesting a route and the FMS pretty much froze. Pressing any LS or alpha/num keys resulted in a 3 - 5 second wait before it did anything

 

2. On three occasions I could not close the cargo doors. Pressing the Close Cargo doors LS keys did nothing and required restarting P3D for them to work

 

3. This is not really an issue per se but I cannot seem to get the FPS past 31 even with the most settings in the middle and AA turned down. I had better FPS with the T7 in FSX.

 

I'll be opening a support ticket with these issues but I am curious to see if anyone else has any of these issues

[downscc 1,327]

Full names in the PMDG forums please Chris.

 

1.  Loading/Requesting route are two different steps and a delay is normal after request is sent and loading also takes around 30 sec or more.  Normal in both FSX and P3D.

 

2.  I'm not an expert in the 77F but don't those doors need hydraulics to operate?

 

3. Ignore FPS as longs as animation is smooth and there's no stutters.  The VC view runs around 25 fps for me but an exterior view will be over 60 fps. I'd consider 31 fps pretty good.