Jump to content
Sign in to follow this  
rpowers

Default 737 has very limited trim wheel travel

Recommended Posts

The trim wheel in my default 737 has a very small travel arc.All other planes have full range.The AP is off.Could I have something else activated that is causing this?Thanks,Ron


Bring back Chief Illiniwek!University of Illinois.

Share this post


Link to post
Share on other sites

Are you unable to trim the aircraft in manual flight?  Just checked default 737 trim wheel, max trim available is showing as +/- 20 degrees.  If Elevator Trim Effectiveness in the .CFG file has been reduced too much from its default value of 1, it may be possible to "run out of trim".  In the 737 I have this value reduced to 0.4 but works ok.

Share this post


Link to post
Share on other sites

Thanks for the response.I p,d around with this all night and found that I deleted the default 737's except for [.0] .and just had my 2 textures for SWA & Air France.When copied the default ones back and just added my 2 everything is good.I love solving problems,especially the ones I create.Ron


Bring back Chief Illiniwek!University of Illinois.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...