Hello.

 

I have sucessfully installed EZDOK onto P3D, and it loads on the startup etc. I can move the camera around with the edit mode.

 

The problem is, if I create a new camera, and start edit mode, it beeps, I move it to a location, stop edit mode. But when I switch to a different view and back, it hasn't changed?

 

Regards

Mads

First thing that comes to mind is make sure you have the proper buttons set in EZDOK for each camera. Sometimes I forget that step when setting up an aircraft.

 

Also, on initial setup, I ALWAYS delete all default EZDOK cameras except the main pilot cam. Then for each new camera, I duplicate that default camera, edit, rename it. I did this to avoid bugs in FSX, and I still do it in P3D. It may or may not help. Worth a try. It's another mindless process I go through when I set up my sim... again... and again... and again...

 

Good luck!

 

Edit - I forgot one step that fixed a similar problem I had in FSX - After duplicating a camera, click on the original camera, then back to the duplicated one before editing. 

Hi.

 

I have pretty much tried all of those steps.

 

Have you got any other ideas?