Not a service based failure?

[Moosehead 5]

Can someone help?

 

Since downloading the new installer and following all the instructions I'm getting an annoying problem...

 

The FMC now starts on the service/failure page but displays no issues.

 

However once it's fired up and ready to taxi, I cannot extinguish the annunciatior panel as the fuel and anti ice are illuminated. There are no faults on the fmc and all the checklists have been followed.

 

This has only started since I updated the ngx. And I've clean installed it twice now to no avail. It happen on all my liveries....

 

Dan

[pete_auau 1,159]

sounds like  the bug   before  the update  from the cold and dark  state.  After you uninstalled the ngx   did you manually  remove any left over  folders  that were left behind  the uninstall  eg  panel states

[codechris 9]

When you uninstalled did you completely remove everything? There is a guide somewhere around here. Sounds like the panel state bug which is known

[Moosehead 5]

I went through the instructions step by step posted on the main pmdg forum and then re installed.

 

I then had to set up my panel saved state again as ngx short turn and as soon as i did, this happens!

 

I've just checked the ops centre and there is (another?) update.... Is that the fix?

[pete_auau 1,159]

What version  have you got installed now.  since if  you just downloaded  the new installer from your pmdg account  just recently  than you should be updated  to the latest  version.  Sounds like some how your install got  screwed up some how

[Moosehead 5]

I'm hoping it has. Just started downloading the installers again that are updated.

 

Thanks for your help and advice!

 

Dan