Take off, yoke problem pmdg 737 ngx

[stijnsarah18 0]

Pilots

 

I have a problem with my pmdg.

 

When i am rolling for take off and the VR call is gone i have to pull my ch yoke to lift.

 

When i pull my yoke it goes always back to 'idle'

when i repeatedly pull on the yoke back and forward my planes lifts en in the air the yoke is normal again.

 

After landing, it starts all again... When on the ground the yoke in the 737 ngx goes always back to idle so i am unable to take off normal

 

Can someone help me with this?

 

i am using fsuipc with the ch yoke, all settings in fsx are deleted.

 

thanx

[downscc 1,327]

Full names in the PMDG forums please.

 

Your yoke is controlling your throttle?? The use of  the word idle can have many meanings here. Try again, when taking off at Vr you lift the nose with the yoke/stick and then what happens? Does the nose lift?

 

When on the ground the yoke goes back to idle?? Keep trying to explain, we will figure this out.

 

Also, make you have set the trim to takeoff value.

[stijnsarah18 0]

The yoke (and airplane) are taking off but less then one second after pulling back the yoke he goes to... let me say the center position (like i am not touching the yoke)

So the plane does not climb...

 

only repeating pull back and a little down and pull back... and so on will lift the airplane...

 

So when i pull my yoke back, the yoke in the pmdg goes directly back to the center position (elevator) i hold my yoke fully backward but the yoke of the pmdg goes to center...

 

All settings in fsuipc are ok. i also unplugged my yoke... i only have this in the pmdg 737...

[joolsd 10]

Have you tried calibrating the yoke? Does it happen in a defalt AC..Don't think it's the pmdg