Hey guys, I'm trying to setup my first flight from Southampton to Geneva

 

I have the below route from PFPX

 

N0389F190 DCT SAM UY8 GWC UN859 ETRAT A34 LGL UN491 TABOV/N0424F430

           UM163 CTL/N0389F190 B37 DJL DJL1N

 

When trying to input the flightplan, inputting SAM VOR is fine and is entered correctly.  When trying to set the UY8 airway by going under the "Load Airways" option, it doesnt seem to recognise it and it ignores the entry and clears itself.

 

I have tried to load in the UN859 after GWC also but it also just ignores the entry.

 

I have the latest AIRAC cycle loaded also.

 

I am loading in airways wrong ?

 

Thanks

 

Dave

 

When trying to input the flightplan, inputting SAM VOR is fine and is entered correctly.  When trying to set the UY8 airway by going under the "Load Airways" option, it doesnt seem to recognise it and it ignores the entry and clears itself.

 

 

Use the 2D panel (Shift+3) for the moment. I reported this issue to Carenado.

Except this, airways work fine.

Hi, I tried the above, but when pressing enter it doesnt do anything, it just keeps flashing on the airway ID

 

You need to give an entry point there. It's either SAM (if it's on that airway) or any other point that is on that airway. Only after you have given the start point that you can chose airway and exit point.