Hello,

 

I installed p3d v3 just fine at the very end a error came up saying " could not write key" assure you adminstrative privilages.

 

Any suggestions?

 

Thanks

 

 

Dino

try installing on a different hard drive or partition... i found having another partition created it was able to pick up the two diff vers easily which is making it a lot smoother for transferring all my ORBX and REX products... currently in the stages of testing each previous aircraft packages i had.... i found sometimes with installing the packs into p3dv3 i had to cancel the installation halfway thru then install again for it to pick up the new location of the P3Dv3

If you accepted the default installation path 

C:\Program Files (x86)\Lockheed Martin\Prepar3D

 

there are often insufficient admin privileges unless you provide them.

This problem happened to me also some error just before the install finished the error code was the same as yours,there is an answer to this issue on LM ,so if you haven't sorted it yet the enclosed link could help,it sorted it for me! P3dv3 installed running fine now

peter

 

http://www.prepar3d.com/forum/viewtopic.php?f=6322&t=113640