October 10, 201510 yr I'm sure this is an FSX:SE/ SimConnect issue, just unsure as to how to avoid/ fix it. I was taking off and clicked the middle of the nav display to better see my SID as I flew it. Once I got to a good point I turned on the AP and clicked the nav display again to put it back into the VC screen. After that I lost my ability to bring up 2D popups by clicking, no ability to turn knobs, click the warning lights, etc. I have to switch to the 2D cockpit and panels to change anything. I had this issue when I first installed and I noticed a readme that came with the T7 installer saying to go and install all those other SimConnect versions. I did that and it seemed to fix it for both planes. I have done several flights so far without issue. This flight though, it seems like something broke while I was flying. Is there any way to fix this or prevent it from happening? Kinda of annoying that I have to go to the 2D to do anything for the next 3 hours... Thanks! EDIT: Windows 10 and FSX:SE are in use here, FSX:SE and PMDG products are a fresh install. No old panel states are being used either. Ryan Parry | Aircraft Dispatcher
October 10, 201510 yr Commercial Member I'm sure this is an FSX:SE/ SimConnect issue, just unsure as to how to avoid/ fix it. Check to ensure your eyepoint hasn't moved into the headrest. This is a bug of the FSX code. Move your eyepoint using the following key commands: CTRL+ENTER/BACKSPACE SHIFT+ENTER/BACKSPACE CTRL+SHIFT+ENTER/BACKSPACE Kyle Rodgers
October 10, 201510 yr Author ahh, didn't even think of this. When I landed and pulled into the gate everything was magically ok. Thanks! Ryan Parry | Aircraft Dispatcher
October 11, 201510 yr Commercial Member ahh, didn't even think of this. When I landed and pulled into the gate everything was magically ok. Likely the viewpoint issue then. The turns while taxiing will definitely move the viewpoint a decent amount. Kyle Rodgers
Create an account or sign in to comment