Good morning everyone,

 

I'm new on the block. For quite some time I haveb een around just lurking for information.

Now I have a question which maybe could be answered by someone.

 

I have P3D V3.1 installed.

All works well to my standards (Unfortunately not a top-of-the bill PC...4 core i5). This however is not causing issues.

 

I have installed the latest Milviz F-4E 160114.exe and, apart from everything else that runs fine, I see no pilots?

I know how to 'activate' those in the "Shift+1", but by doing so, the dialog opens but contents are not shown. So, I cannot change anything.

 

Question:

Can such be set in a specific.ini file? If so, which one?

 

Would be great receiving some feedback on this and shall be appreciated.

 

Regards,

GIBF4

The Netherlands, Europe

 

Why doen't you ask this question at the Milviz support forum?

http://www.milviz.com/forum/viewforum.php?f=16

Spirit

Hello Spirit,

 

As I said, I'm new here and obviously too 'fresh' regarding the various forum topics....Only myself to blame.

Thanks for your advise. I shall turn right there now.

 

GIBF4