spirit_66
Members
-
Joined
-
Last visited
Everything posted by spirit_66
-
-
It obviously didn't help much. Spirit
-
One can monitor the GPU with GPU-Z a freeware tool very well. I doubt that your card run out of memory. Spirit
-
Looks like that your research wasn't quite deep enough. Spirit
-
One can find it here and on other places too. http://forums.guru3d.com/showthread.php?t=406876 Spirit
-
Installed the newest GeForce drivers 364.91 using the DDU tool for a clean install and everything is fine - as always. I guess this old driver 353.30 isn't ok for W10. Spirit
-
-
Make a test with DSR setting to a higher resolution then you also know the impact. Spirit
-
Why doen't you ask this question at the Milviz support forum? http://www.milviz.com/forum/viewforum.php?f=16 Spirit
-
The newest is always the best. Spirit
-
Where did you get this information from? P3D v3 works very well with HT. Spirit
-
-
+1 ...... +1 Spirit
-
Just did the FireStrike benchmark test with my ASUS GTX780TI and reached 11351 scores. Spirit
-
Indeed, no surprise that the GTX980 can't give you much more performance compared to the GTX780. You should investigate why your CPU isn't able to feed your GPU much better. I had no problems to load my GTX780TI above 90%. Spirit
-
So let it be if it is this way. Spirit PS: You can give P3D v3 a higher priority too.
-
Easy to check what AM P3D v3 is using. I guess it's no need to put it into the config-file. P3D knows the best by itself. Spirit
-
Did you monitor your card with something like GPU-Z to see the load of the GPU? The load of the CPU would also be of interest at the same time. I use Real-Temp for this. I think your CPU can be a bit OC. Is the GPU already OC? Spirit
-
Does it matter what I think? Spirit
-
Hi Jim, that's very strong tobacco what you're telling us here. I doubt that you got the virus from DDU directly. Did you mention this at the guru3d forum? As far as I know is the author of DDU a member there. http://forums.guru3d.com/showthread.php?t=379506 It would be very helpful to explain your problem there and tell where you downloaded it. Only to say you got a virus from DDU is useless for the community. Thanks Spirit
-
+1 Spirit
-
Maybe you change the wrong prepar3d.cfg? Spirit
-
Works very well with Force Feedback tool and FSUIPC but the G940 itself is really not worth the money. Setting the axis in FSUIPC not in P3D2 is the best way. Spirit
-
You may look here. http://forums.guru3d.com/showthread.php?t=399677 Spirit
-
Thanks for the heads up. Spirit
