November 23, 20169 yr One of my quadrant axes is spiking badly. I have read all the threads on this forum and others and am now prepared to open up the beast and try to clean the pots. However, while preparing for this, I have come across an issue that I have not seen mentioned anywhere: crosstalk. When I move the left lever full range, the values coming out of the MIDDLE channel change (with a lot of noise) by a few 1000s (out of -16k/+16k), although its lever does not move at all. I monitor the values with FSUIPC. This seems to point to some electrical fault. Has anybody else experienced this? and,better still, can offer a solution? Thanks, Phil
Archived
This topic is now archived and is closed to further replies.