vPilot and Com2 freq. change using .com2 command

[cxa106 0]

Did'nt find how to change the Com2 frequency via the keyboard.

Am I missing something here.

Thanks!

[scandinavian13 5,192]

8 hours ago, cxa106 said:

Did'nt find how to change the Com2 frequency via the keyboard.

Am I missing something here.

Thanks!

Welcome to the forum. Please note that full names - first and last - are required to be placed in your posts here.

As far as your issue goes, this sounds like an issue to be discussed in a vPilot forum. We have no control over that program.

[tbarker1989 1]

.com2 will change the com 2 frequency. The caveat to this is are you using in the settings to disable comms if misconfigured. If so then check to see if you have the radio on to receive where the light is on above the dial. Not the mic but the radio. Remember VHF-L is comm 1. VHF-C is typically a data connection. VHF-R is comm 2. Once you select the VHF-R to be able to receive. you should be able to change that frequency with .com2 command. You will not be able to transmit on it until you select the mic button.

Hope this helps,