May 12, 20179 yr I have spent a lot of time trying to work out the following: 1. Each camera zooms out to the max, when I zoom in using the = - and save, it's ok until I use another camera then come back to the one I adjusted. (its zoomed out again) If I use the zoom in the camera controls section, it will zoom in, but back to center when I let go of the mouse (default action I think) 2. When I open the UI, the sim pauses? I don't remember it doing that before unless I'm wrong? Pete Markovic
May 12, 20179 yr Author I have uninstalled chaseplane via the control center, rebooted the computer, reinstalled and nothing has changed, all my settings are still there. How can this be? Pete Markovic
May 13, 20179 yr Author Anyone? My main issue now is I cannot change the zoom on my cameras from 3.0, if I zoom in, it just returns to 3.0. :( Very frustrating, I did find another post which others have had the same problem and suggested switching of the realtive axis, I have none using that option that I can see. Pete Markovic
May 13, 20179 yr Commercial Member Have you tried setting a dead-zone when assigning your axis? Keven Menard Technical Director, //42.
May 13, 20179 yr Author I just reassigned all my axis on my Xbox controller and enlarged the dead zone. No change, eg, I have 2 buttons assigned to the zoom in and out, I can zoom in, and as soon as I let go of the button, it zooms back to 3.0 by itself. I did send an email to support last night in relation to all this. I forgot to mention I'm using Prepar3d 3.4 Pete Markovic
Archived
This topic is now archived and is closed to further replies.