Not Communicating To FSUIPC

[Fleahead 8]

FSUIPC 5.121b Registered + LINDA 3.0.3.724 + P3DV4.1

The summary page in LINDA shows  "Everything is OK!" in all Configuration checklists. Sync To Sim is active. When I operate the various buttons they respond in the Joystick configuration windows.

I assigned any basic command to any button in LINDA and save it, the sim does not respond to the button. If I assign the same command to the same button in FSUIPC, it works properly. I assigning the same command to a keystroke in FSUIPC and that operated properly, but if I assign the same keystroke to a button in LINDA, it doesn't work. That is telling me that there is no communication between LINDA-FSUIPC.

I have tried this with different aircraft and it doesn't matter if I use Saitek or CH controllers.

[ScotFlieger 280]

Hi Fleahead

Sorry to hear about you Issue and thank you for the comprehensive summary. It sounds like LINDA LUA code has a problem. Open the LINDA Console and check that there are no error lines. You also don’t say what aircraft you are using.

Please follow the Fault Diagnosis reporting thread and let me see your log files. 

[Fleahead 8]

I've tried Carenados A36 Bonanza, A2A B17, LMs Maule that comes on P3D. It doesn't matter.

No logging info comes into the console at all from FSUIPC. Everything is turned on to log.

------------ NEW LOGGING SESSION - LINDA 3.0.3.724 --------------
### Blocked: attempt made to change LogOptions via 3400, data 0x0001
FSUIPC logging bit cleared: 2
### Blocked: attempt made to change LogOptions via 3400, data 0x0001
FSUIPC logging bit cleared: 10
### Blocked: attempt made to change LogOptions via 3400, data 0x0001
FSUIPC logging bit cleared: 6
### Blocked: attempt made to change LogOptions via 3400, data 0x0005
FSUIPC logging bit set: 2
### Blocked: attempt made to change LogOptions via 3400, data 0x0401
FSUIPC logging bit set: 10
### Blocked: attempt made to change LogOptions via 3400, data 0x0041
FSUIPC logging bit set: 6
[EVNT] LUA logging switched on - Level 1

 

I'll look for the fault files

[Fleahead 8]

I just sent the log files

 

[ScotFlieger 280]

If there is no logging in the Console what LINDA debug level do you have set? You need to set VERBOSE (as described in the Fault Diagnosis thread). You also need to edit FSUIPC5.ini to change the LogOptions entry. I have emailed you asking for the FSUIPC5.log but can you also send me the FSUIPC5.ini too?

[Fleahead 8]

Just as a shot in the dark, I re-downloaded then re-installed LINDA, and now it is functioning. Go figure...

 

Thanks for your prompt assistance, Andrew!

[ScotFlieger 280]

You are very welcome. Enjoy!