i am completing a full reinstall of fs 9 and have been iadding lots of new sceneries. recently i noted that after creating a new flight, i cannot select runways or gates; only the default runway is listed. the problem is not usually seen immediately after fs9 opens, but seems to be present after closing one flight and creating a new flight. if the problem is there, it affects virtually all airports. it ususally goes away when the sim is closed and then reopened.i cannot figure out which of the new sceneries might be responsible, because i cnnot pinpoint when the problem started. i noticed it after i installed jan martins terminals and gates sceneries, plus all of the newer afcads available on his site. the absence unavailablilty of runways affects airports other than the ones for which he has afcads. the problem is not fixed by simply disabling his sceneries. i have not tried to remove all of his afcads since the problem is not limited to the airports with those afcads. is it possible for one afcad to affect this fs function?can anyone suggest some causes for this problem and some fixes as well?steve chavin

Hi,Inactivate half of your addon sceneries (the newer ones would be logical) and then run the sim for a while. Problem went away? Add back half of the ones you inactivated. Try it for a while. Problem back? It was in those you added - inactivate half of them. Continue this process until you find the culprit.Hope this helps,--Tom GibsonCal Classic Propliner Page: http://www.calclassic.comFreeflight Design Shop: http://www.freeflightdesign.comDrop by! ___x_x_(")_x_x___