why my 748 rte data data link "no comm"

[Dlwlrma 0]

i use AS16P4 but the fmc RTE DATA   DATA LINK “NO COMM"

[Olympic260 415]

17 minutes ago, Dlwlrma said:

i use AS16P4 but the fmc RTE DATA   DATA LINK “NO COMM"

 Welcome to the forums, please note that PMDG requires that users include a signature block with the user's name, first and last, in all posts in the PMDG forum.
Failure to include a signature will result in removal of the post without comment.

We strongly encourage users to set up a signature block in their AVSim user account, then you never have to worry to remember in the future!

 

Regarding your issue check below, also mentioned in the intro document

https://support.precisionmanuals.com/kb/a126/loading-a-rte-via-datalink.aspx

[Dlwlrma 0]

7 minutes ago, Olympic260 said:

 Welcome to the forums, please note that PMDG requires that users include a signature block with the user's name, first and last, in all posts in the PMDG forum.
Failure to include a signature will result in removal of the post without comment.

We strongly encourage users to set up a signature block in their AVSim user account, then you never have to worry to remember in the future!

 

Regarding your issue check below, also mentioned in the intro document

https://support.precisionmanuals.com/kb/a126/loading-a-rte-via-datalink.aspx

thanks olympic260 now my signature is Correct？

[Olympic260 415]

Yes thank you

[Dlwlrma 0]

19 minutes ago, Olympic260 said:

Yes thank you

There is another problem.why my nd airport map is too old，I use Newest ImagineSim ZSPD，In my P3D，ZSPD have 4 runways，but in 748,the nd airport map just only 2 runways in nd airport map

Edited September 27, 2018 by Dlwlrma

[Olympic260 415]

27 minutes ago, Dlwlrma said:

There is another problem.why my nd airport map is too old，I use Newest ImagineSim ZSPD，In my P3D，ZSPD have 4 runways，but in 748,the nd airport map just only 2 runways in nd airport map

You need to scan your scenery. I recommend to go over the introduction manual. Page 180  onwards.

[JRBarrett 3,113]

31 minutes ago, Dlwlrma said:

There is another problem.why my nd airport map is too old，I use Newest ImagineSim ZSPD，In my P3D，ZSPD have 4 runways，but in 748,the nd airport map just only 2 runways in nd airport map

You need to scan your add-on airports to build a database for the moving map. See page 23 of the EFB manual.