ATC repeats instructions, although complied with

[john1383 3]

I have been doing my usual short IFR test flight from EGNT to EGPH in the Realair Duke at 10,000ft, in which P2ATC is working perfectly, except for a tiny anomaly.

After take off from EGNT, after a short while I am instructed to contact Newcastle radar director on 125.82, this instruction repeats twice. I then tune to this frequency and call it up as usual, but the instruction repeats , again twice, exactly as before.

Actually, I don't remember that particular frequency being listed on the EGNT frequency tab before, but could be mistaken.

If I do nothing eventually an ATC instruction comes to contact a frequency that does respond as expected.

This problem happens in v 2.5.0.6  64bit V3 and 5 (don't know about 4)

Not a big issue , but everything else is working fine for me!

Lovely program!