Hi, new here. I've  heard very good things of the gtn750 for Xplane. I'm looking to integrate this into my home cockpit setup. However, because I run a separate computer for the avionics in a master slave Xplane configuration, I was wondering if it would be possible to run this plugin I  the slave avionics computer and have it talk to the master. Would this plugin work in a setup like this?

It's not possible to run  this on the main  PC, Wich runs on Linux

Thanks again

Hi,

I really don't know whether this works or not.

I'd say if any other plugin can work in the 'client' PC normally, which means it is capable of displaying a window, and read/write datarefs, I'd guess our plugin would then work?

Do you run any known plugin already on the 'client' PC?

Edited December 22, 20187 yr by RXP

Hi, thanks for the answer. The slave is a full xplane copy so it should be able to run a plug in and read datarefs. Regarding dataref write i believe its posible to enable this functionality. Do you have a list of datarefs the plugin needs read/write access?

Also by chance have you tested this in linux runing the simulator on wine (windows emulator)? I have tested myself the Garmin trainer software on wine and works

Regarding the license its possible to install in only one computer? Or more? I may need to test different combinations so more than one installation may be required.

Thanks again

 

Hi,

Unfortunately the list would be too long/complex and it depends on the GTN Device setings in-sim.

We've not tested under linux but we were not satisfied with our experimentation on macOs along similar lines.

The EULA grant you the right to install on 2 computers (typically desktop and laptop) provided you don't run both at the same time. You won't be limited to do your experimentation.