Having finally gotten around to getting the above, I find myself stuck at the install stage!

I've basically just installed and run P3D 4.5 as a full install onto a clean drive, rebooted and it all works fine.

I've now tried to install the Maddog X 3 times, including turning off Defender and UAC and redownloading too.  On every occasion, the installer appears to run OK and is followed by the install of TrueGlass and RealLight, but never by the next step, which is to point to the P3D.exe.

As a result, the Loadmanager will not start and that means I can't register the product, nor gain access to the support forums.

I've been around for quite a while now, but must say, this has me stumped.

I submitted a support ticket concerning the lack of support forum access which Stefano replied to, and yesterday raised this query as well.  But since I got the Maddog X 3 days ago, I thought it worth seeing if anyone here has any ideas (Dave? 🙂 )

The only other clue I can offer is the error message I got at the end of each install, that also appears if I try and run the Load Manager: maddog-lm.exe - Application Error, The application was unable to start correctly (0xc0150002)

Suggestions? 

34 minutes ago, Paul Golding said:

Having finally gotten around to getting the above, I find myself stuck at the install stage!

I've basically just installed and run P3D 4.5 as a full install onto a clean drive, rebooted and it all works fine.

I've now tried to install the Maddog X 3 times, including turning off Defender and UAC and redownloading too.  On every occasion, the installer appears to run OK and is followed by the install of TrueGlass and RealLight, but never by the next step, which is to point to the P3D.exe.

As a result, the Loadmanager will not start and that means I can't register the product, nor gain access to the support forums.

I've been around for quite a while now, but must say, this has me stumped.

I submitted a support ticket concerning the lack of support forum access which Stefano replied to, and yesterday raised this query as well.  But since I got the Maddog X 3 days ago, I thought it worth seeing if anyone here has any ideas (Dave? 🙂 )

The only other clue I can offer is the error message I got at the end of each install, that also appears if I try and run the Load Manager: maddog-lm.exe - Application Error, The application was unable to start correctly (0xc0150002)

Suggestions? 

I know your an old hand Paul, but did you remember to install sinconnect ?. Net framework up to date. It's as if it's calling for something that is not there, especially if it fails at the same spot.

Sh1t!  Maybe "old" is the operative word🤣

Thanks for that👏

5 minutes ago, Paul Golding said:

Sh1t!  Maybe "old" is the operative word🤣

Thanks for that👏

LOL

Now to do some reading, after doing the obligatory ctrl+e circuit with no ND working, and no flaps either.  Quite shocked that I managed to get on to a 5,000 runway like that!

Thanks again.

EDIT:  I'd also like to point out that having checked the spam folder, Stefano had actually replied yesterday, also pointing to simconnect.  So great service via their ticket system.

Edited July 19, 20196 yr by Paul Golding

Glad it installed in the end Paul